* To prevent hardening, the anaerobic adhesive should be in contact with air. A large 120ml container was filled with 50ml of contents. There is only half of the bottle, but the contents are 50ml. * Safety Precautions Keep out of reach of children. * Preparation Protect work area. Parts to be sealed must be clean and dry. Shake the product thoroughly before use. Note: To prevent the product from clogging in the nozzle, avoid touching the bottle tip to the metal surface. * Application For Thru Holes: Apply several drops of the product onto the bolt at the nut engagement area. For Blind Holes: Apply several drops of the product down the internal threads to the bottom of the hole. Assemble parts and tighten as required. Sets in approximately 10 minutes and fully cures in 24 hours. * Cleanup Clean adhesive residue immediately with a damp cloth. Cured product can be removed with a combination of soaking in methylene chloride and mechanical abrasion such as a wire brush. For disassembly, shear with standard hand tools and remove with methylene chloride. In rare instances where hand tools do not work because of excessive engagement length, apply localized heat to nut or bolt to approximately 482°F (250°C). Disassemble while hot.
Prevents loosening from shock and vibration.
No corrosion or abrasion, Can be disassembled if necessary, Easy assembly by anyone.
Can be used on various sizes of fasteners - reduces inventory costs.
Permanently locks studs and press fits.
Medium strength thread locker for fasteners up to 3/4". Cures reliably even on stainless steel. Tolerant of oil and other contamination. Protects threads from rust and corrosion. Parts can be disassembled with hand tools. Temp range -65 to 300 degrees F. Cure speed 15 min. Full 24 hrs.